< Products

Aquapac Waterproof Case for Wire-Out Electronics - Large ( Connected Electronics Case )

£39.00 £45.00

When a wireless connection isn’t possible, this case allows you to stay plugged in whilst protecting your equipment from immersion.

Also works with some pulmonary hypertension pumps.

Stormproof to IPX6 - protected against powerful water jets

Can people swim with it?
Our testing shows that the TC clamp will let a tiny amount of water in after a period of total immersion. So the best advice we can give is to wear it in the small of your back if you’re swimming on your front, and on your tummy if you’re swimming on your back, so that it spends as little time submerged as possible. We are talking here about splashing around in the pool or the sea, but we are NOT talking about endurance/long-distance swimming.

This case is designed for electronics which require a thin wire to be connected to them at all times.

The special wire-thru clamp at one end allows that wire to stay connected, and be waterproof.

The case is usually used by professionals with specialist electronic devices, but could be used for a permanently connected small tablet, large phone or audio player.

Key Features

Use all buttons and switches through the case
Like most of our cases it’ll float if you drop it in the drink
Feed out a wire of up to 1/10th inch / 2.5mm diameter from the case
The seams are high-frequency welded to form a super-strong bond
Waterproofness Warning!: This case features our ‘TC’ Aquaclip which makes the case waterproof to IPX6 (a quick dunking should be fine, but not prolonged immersion).
As used by film crews and sound engineers all over the world!
The other two sizes are the 158B Radio Microphone Case and 558 Connected Electronics
Made in the UK

Techy Bits, Dimensions & Weight

Materials : TPU
Colour : Cool grey with grey belt and acid green lanyard
Weight : Case: 3.1oz / 87g Belt: 2.1oz / 59g Lanyard: 0.2oz / 7g
Dimensions : See attached image

Important Note regarding Insulin Pumps and Aquapac cases

Aquapac commissioned research by Imperial College London into the suitability of their cases for use with insulin pumps. Results show that in some circumstances insulin flow rate can be reduced by the case. In particular, low flow rates are impeded and as such Aquapac can make no claim regarding the suitability of these cases with insulin pumps. Use of these cases with insulin pumps is entirely at the discretion of the user.

We are advised to recommend that users of Aquapac cases with insulin pumps regularly check their blood sugar levels. Furthermore we strongly recommend that you get the green light from your consultant before use.

The tests were conducted by Imperial College of Science, Technology and Medicine using a Roche Accu-Check Spirit insulin pump at a temperature of 20C at flow rates of 2U/hr and 10U/hr. The amounts of insulin delivered over 60 minutes observed were as follows:

2U/hr not in a case – 0.0131g (flow rate of 100%)
2U/hr in Aquapac 150 – 0.0106g (flow rate of 81%)
2U/hr in Aquapac 150 – 0.0056g (2nd test model)(flow rate of 42%)
2U/hr in Aquapac 550 – 0.0121g (flow rate 92%)

10U/hr not in case – 0.0864g (flow rate of 100%)
10U/hr in Aquapac 150 – 0.0878g (flow rate of 100%)
10U/hr in Aquapac 550 – 0.0903g (flow rate of 100%)

21st August 2006

Category: aquapac waterproof case for wire out electronics large, bags, comms, dry bag, dry bags, drybag, lifestyle, packages, safety